LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (27 Starter, Power Supply, Cruise Control 2.9L Turbo Hybrid -- 971 - PANAMERA (971)) >> WM, 279619 Removing And Installing Left Charging Socket >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Incorrect handling of high-voltage components 
  • Electric shock 
  • Short circuit 
  • Fire 
  • Explosion 

    → Only appropriately trained and authorized persons may work on high-voltage vehicles and components.

    → Required qualification: high voltage technician or high voltage expert.

    → Observe national requirements and legislation for this work.

    → Always use insulated tools, such as an > VAS 6883 - insulated tool set  when working on these parts.

    → Observe general warning notices for working on the high-voltage system.

    → > 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM

  1. Install high-voltage charger.

    > 279719 REMOVING AND INSTALLING HIGH-VOLTAGE CHARGER 

  2. Install subwoofer.

    > WM, 913619 REMOVING AND INSTALLING SUBWOOFER

  3. Install rear wheel housing liner at the left.

    > WM, 536919 REMOVING AND INSTALLING REAR WHEEL HOUSING LINER

  4. Install side section flap.

    > WM, 554055 REPLACING SIDE SECTION FLAP (MODULE)

  5. Start the vehicle again and complete the relevant documentation.

    > 2X00IN ISOLATING HIGH-VOLTAGE ELECTRICAL SYSTEM FROM POWER SUPPLY/STARTING HIGH-VOLTAGE ELECTRICAL SYSTEM

  6. Complete documentation.

    > 2X00IN TEST LOG: STARTING THE HIGH-VOLTAGE SYSTEM

  7. Read out the fault memory and erase it if necessary.