Installing Charging Socket

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Incorrect handling of high-voltage components

Electric shock
Short circuit
Fire
Explosion
→ Only appropriately trained and authorized persons may work on high-voltage vehicles and components

→ Required qualification, high voltage technician or high voltage expert.

→ Observe national requirements and legislation for this work.

→ Always use insulated tools, such as an > VAS 6883 - insulated tool set when working on these parts.

→ Observe general warning notices for working on the high-voltage system.

→ > 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM

Information

Check that the high-voltage connectors are engaged fully by carrying out a visual inspection and by pulling gently on the high-voltage connectors.

Information

Make sure that the water drain is not kinked.

Installation is performed in reverse order. Pay particular attention to the following:
Screw in and tighten fastening screw securing ground line to body > Tightening torque 8 Nm (6 ftlb.)

Screw in and tighten fastening screws securing charging socket to body > Tightening torque 5.6 Nm (4 ftlb.) + 0.6 Nm (0.3 ftlb.) - 0.8 Nm (0.4 ftlb.)