Removing Pilot Line Connector
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Incorrect handling of high-voltage components
- Electric shock
- Short circuit
- Fire
- Explosion
→ Only appropriately trained and authorized persons may work on high-voltage vehicles and components.
→ Required qualification High voltage technician or high voltage expert.
→ Observe national requirements and legislation for this work.
→ Always use insulated tools, such as an > VAS 6883 - insulated tool set when working on these parts.
→ Observe general warning notices for working on the high-voltage system.
→ > 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM
- Unclip pilot line connector.
- Release cover -1-
using a suitable tool -2-
and remove it from the housing -3-
(-arrows-
).
Cover on pilot line connector
- Loosen fabric adhesive tape on electric line at the end of the connector and cut it off.
- Release secondary lock -1-
using a suitable tool -2-
(-arrow-
).
Secondary lock on pilot line connector
Information
Caution! Risk of damage to locking lugs.
- Release pins using press-out tool -2-
from > VAS 1978/35-20 - Release Tool Set
and pull them out carefully at the electric line -3-
.
Pilot line connector pins
- Release clip -1-
from the old pilot line connector -2-
using a suitable tool -3-
and pull it off -arrow-
.
Clip on pilot line connector