Subsequent Work

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Incorrect handling of high-voltage components

Electric shock
Short circuit
Fire
Explosion
→ Only appropriately trained and authorized persons may work or high-voltage vehicles and components.

→ Required qualification: High voltage technician or high voltage expert.

→ Observe national requirements and legislation for this work.

→ Always use insulated tools, such as an > VAS 6883 - insulated tool set when working on these parts.

→ Observe general warning notices for working on the high-voltage system.

→ > 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM

Install PASM control unit.
> 431619 REMOVING AND INSTALLING PASM CONTROL UNIT
Install high-voltage charger.
> 279719 REMOVING AND INSTALLING HIGH-VOLTAGE CHARGER
Install side trim panel for rear luggage compartment.
> WM, 700319 REMOVING AND INSTALLING SIDE TRIM PANEL FOR REAR LUGGAGE COMPARTMENT - Coupe or WM, 70031930 REMOVING AND INSTALLING SIDE TRIM PANEL FOR REAR LUGGAGE COMPARTMENT - Wagon
Start the vehicle again and complete the relevant documentation.
> 2X00IN ISOLATING HIGH-VOLTAGE SYSTEM FROM POWER SUPPLY/STARTING HIGH-VOLTAGE SYSTEM

> WM, 261420 REMOVING AND INSTALLING HEAT SHIELDS
Complete documentation.
> 2X00IN TEST LOG: STARTING THE HIGH-VOLTAGE SYSTEM
If the HV battery control unit was replaced, teach the new HV battery control unit using > 9900 - PIWIS Tester 3 .
> 279455 REPLACING CONTROL UNIT FOR HV BATTERY
Read out the fault memory and erase it if necessary.