General Warning Notices

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Incorrect handling of high-voltage components

Electric shock
Short circuit
Fire
Explosion
→ Only appropriately trained and authorized persons may work on high-voltage vehicles and components.

→ Required qualification: High voltage technician or high voltage expert.

→ Observe national requirements and legislation for this work.

→ Always use insulated tools, such as an > VAS 6883 - insulated tool set when working on these parts.

→ Observe general warning notices for working on the high-voltage system.

> 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM

Information

Observe the following specifications for all work described:

country-specific, national, legal and official regulations,
local restrictions and export restrictions,
manufacturer's specifications from component and vehicle manufacturers,
component-specific specifications.

These strict specifications apply in particular:

Storage, installation and removal, transport and disposal of vehicles, assemblies, operating materials and auxiliary materials,
handling of defective and potentially hazardous vehicles as well as assemblies,
handling of battery electric vehicles and high-voltage components.
For this purpose, take into account relevant and qualified information sources such as local authorities, responsible importers, associations and specialist website. Deliver items to be disposed of only to authorized reception points.

Information

Handling high-voltage lines:

Do not support yourself or your tools on high-voltage lines and their components.
Work involving metal-removing, deforming and sharp-edged tools close to high-voltage components and lines is prohibited.
Work involving heat sources such as welding, soldering, hot air and thermal bonding close to high-voltage components and lines is prohibited.
High-voltage lines must not be extensively bent or kinked.
High-voltage lines (screwed connections) have 5 mating cycles. If these 5 mating cycles are exceeded, a visual inspection of the high-voltage connectors must be performed. Then contact Technical Support.
In the event of queries or uncertainties, consult the relevant high voltage technician.