Injection System

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Injection System Components Location With Torque Specification - V6 Biturbo

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Injection system V6 biturbo

1	High-pressure pump
2	High-pressure pump piston
3	Screws, M8 x 25 > Initial tightening 20 Nm (14.8 ftlb.) > Final tightening + 45°
4	Fuel collection pipe
5	Screw, M6 x 16 > Tightening torque 9 Nm (6.6 ftlb.)
6	Fuel collection pipe
7	Adapter > Tightening torque 40 Nm (29.5 ftlb.)
8	High-pressure fuel line/Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. /Observe the tightening sequence
9	High-pressure fuel line connection between bank 1 and 2/Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. /Observe the tightening sequence
10	Clamps
11	M6 screw
12	Fuel line flow
13	Support
14	Fuel pressure sensor for high pressure > Tightening torque 25 Nm (18.4 ftlb.)
15	M6 nut > Tightening torque 9 Nm (6.6 ftlb.)
16	Fuel pressure sensor for low pressure > Tightening torque 15 Nm (11.1 ftlb.)
17	Low-pressure fuel line distributor/Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. /Observe specified tightening sequence > Tightening torque 8 Nm (5.9 ftlb.) > Tightening torque 60°
18	Screw, M6 x 12 > Tightening torque 9 Nm (6.6 ftlb.)

Fig 2: Shield For High-Pressure Pump Components Location With Torque Specification

Courtesy of PORSCHE CARS NORTH AMERICA, INC.