Installing All-Wheel Final Drive
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Observe specified tightening torques and tightening sequence. Fit a new circlip.
- 1.1 Clean input flange on all-wheel final drive and connecting shaft at the splines and apply a light coating of new assembly paste (see PET).
- 1.2 All-wheel final drive - observe tightening sequence
> Tightening torque 54 Nm (40 ftlb.)
- 1.3 Console
> Tightening torque 54 Nm (40 ftlb.)
- 1.4 Engine carrier to engine
> Initial tightening 50 Nm (37 ftlb.)
> Final tightening + 90°
- 1.5 Engine mount to engine carrier
> Tightening torque 55 Nm (41 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tightening sequence for front-axle final drive and console