Removing Engine

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect coolant line at the power electronics.
> 279119 REMOVING AND INSTALLING POWER ELECTRONICS FOR HIGH-VOLTAGE SYSTEM
Disconnect coolant line -1- at the front.
1. 2.1 Loosen clamp -arrow - and pull off coolant line -1- .
2. 2.2 Collect emerging coolant.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant line on change-over valve
Disconnect coolant line -1- at the ATF cooler -2- .
1. 3.1 Loosen clamp -arrow- and pull off coolant line -1- .
2. 3.2 Collect emerging coolant.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant line on ATF cooler
Disconnect coolant lines -1- on the front-axle carrier -2- at the left.
1. 4.1 Open holder -arrows- and disconnect coolant lines -1- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant lines on front-axle carrier

Left side of engine:

5.1 Loosen engine mount -4- from engine carrier -5- .
1. 5.1.1 Loosen and unscrew screw -3- .

5.2 Press drive shaft -1- off the all-wheel final drive bracket -2- (-arrow- ) and guide it out carefully.

> WM, 404119 REMOVING AND INSTALLING FRONT DRIVE SHAFT

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drive shaft and left engine mount (V8 biturbo engine)

Right side of engine:

6.1 Loosen engine mount -4- from engine carrier -5- .
1. 6.1.1 Loosen and unscrew screw -3- .
6.2 Lift the engine up slightly.

6.3 Press drive shaft -1- off the all-wheel final drive -2- and guide it out carefully.

> WM, 404119 REMOVING AND INSTALLING FRONT DRIVE SHAFT

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drive shaft and right engine mount (V8 biturbo engine shown)

Remove engine from front-axle carrier.