Mounting Engine

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Mount engine on front-axle carrier.
1. 1.1 Lower engine with workshop crane and > 3033 - lifting tackle onto the front-axle carrier and move it into installation position.

Left side of engine:

2.1 Carefully guide in drive shaft -1- and insert it into the all-wheel final drive bracket -2- (-arrow- ). Check that the drive shaft is seated securely.
> WM, 404119 REMOVING AND INSTALLING FRONT DRIVE SHAFT

2.2 Fit engine mount -4- on engine carrier -5- .

2.2.1 Fit and tighten screw -3- .

> Initial tightening 70 Nm (52 ftlb.)

> Final tightening + 90°

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drive shaft and left engine mount (V8 biturbo engine)

Right side of engine:

3.1 Carefully guide in drive shaft -1- and insert it into the all-wheel final drive -2- (-arrow- ). Check that the drive shaft is seated securely.
> WM, 404119 REMOVING AND INSTALLING FRONT DRIVE SHAFT

3.2 Fit engine mount -4- on engine carrier -5- .

3.2.1 Fit and tighten screw -3- .

> Initial tightening 70 Nm (52 ftlb.)

> Final tightening + 90°

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drive shaft and right engine mount (V8 biturbo engine shown)

Secure coolant lines -1- to the front-axle carrier -2- at the left.
1. 4.1 Secure coolant lines -1- in the holders -arrows- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant lines on front-axle carrier
Secure coolant line -1- to the ATF cooler -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant line on ATF cooler
Secure coolant lines -1- at the front.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant lines on change-over valve
Secure coolant line to the power electronics.
> 279119 REMOVING AND INSTALLING POWER ELECTRONICS FOR HIGH-VOLTAGE SYSTEM