Installing Balance Shaft (V6 Turbo)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Move balance shaft -1-
into installation position and attach the balance weight -2-
to the balance shaft -1-
. The milled surface -arrow
on the balance weight must be seated on the milled surface on the balance shaft.
Milled surface of balance weight
- Fit end plate -2-
for balance shaft -3-
.
- 2.1 Fit new seal for end plate -2- .
- 2.2 Fit thrust washer -4- on the balance shaft -3- .
- 2.3 Position end plate -2- , fit new screws -1- and tighten to > Tightening torque 9 Nm (6.5 ftlb.) .
Balance shaft end plate