Removing Camshaft Controller Actuator

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

The steps to be carried out are described and shown for one side of the vehicle. They also apply for the other side of the vehicle and can be used accordingly.

Have suitable aids ready to collect emerging fluids and have suitable stoppers ready for closing off connection openings.

Only for removing camshaft controller actuator at the intake side of the right cylinder bank:

Disconnect coolant pipe -2- .

2.1 Unscrew screw -1- and disconnect coolant pipe -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Lower coolant line

Only for removing camshaft controller actuator at the intake side of the right cylinder bank:

Disconnect upper coolant line.

3.1 Slide insulation -1- aside.
3.2 Unscrew nut for coolant pipe holder -3- .
3.3 Loosen spring band clamps -2- using > VAS 6890 - Spring Band Clamp Pliers and pull off coolant hose.

3.4 Close off connections with stoppers.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Upper coolant line

Move coolant pipe -2- with hose piece -3- aside.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Lower coolant line
Remove camshaft controller actuator.
1. 5.1 Release and disconnect electric plug connection -1- .
2. 5.2 Unscrew screws -2- .
3. 5.3 Remove camshaft controller actuator -3- (On outlet side: with heat shield).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Camshaft controller actuator