Technical Values
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Double screw for additional coolant pump (castor) | M6 x 14/M6 x 14 | Tightening torque | 9 Nm (6.6 ftlb.) | ||
| Screws securing additional coolant pump (castor) to holder | Tightening torque | 1.5 Nm (1.1 ftlb.) | |||
| Screws for coolant pipe on left cylinder bank | Tightening torque | 9 Nm (6.6 ftlb.) | |||
| Screw for chain housing cover on cylinder bank 1 | M6 x 22 (8 ea.)/replace, observe specified tightening sequence | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Screw for chain housing cover on cylinder bank 2 | M6 x 22 (7 ea.)/replace, observe specified tightening sequence | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Fastening screw for high-pressure fuel line | Replace | tightening torque | 8 Nm (5.9 ftlb.) | ||
| Fastening screw for high-pressure fuel line | final tightening torque | 45° | |||
| Union nut for fuel line | Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. | tightening torque | of 10 Nm (7.4 ftlb.) | ||
| Union nut for fuel line | Coat thread on union nut with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting. | Torque angle | 60° |