LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (21 Exhaust Gas Turbocharging 2.9L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 213919 Removing And Installing Pressure Hose (V6 BITURBO) >> Installing Pressure Hose >> Installing Moulded Hose

Installing Moulded Hose

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install moulded hose -1-  from charge-air cooler to intake distributor.
    1. 1.1 Tighten screw-type -Arrows-  clamps to > Tightening torque 5.5 Nm (4 ftlb.) +/- 0.5 Nm (0.3 ftlb.)  .
    G15877341Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Moulded hose from turbocharger to intake distributor (right illustration)

scientia non olet · About LEMON Manuals