LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (44 Wheels, Tyres, Suspension Alignment 2.9L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 449503 Performing Front And Rear Suspension Alignment >> Measuring And Adjusting Wheel Alignment On Front And Rear Axle >> Adjusting Front-Axle Toe

Adjusting Front-Axle Toe

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clamp steering wheel in Centre position with steering wheel holder -A -  . Use steering wheel holders that do not project into the area of the airbag unit -B -  . If necessary, shorten the guide rod of the steering wheel holder at the top -Arrow-  .
    G15858273Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Steering-wheel holder (example)

    For fast and reliable steering wheel alignment in Centre position, use a > VAS 6826 - steering wheel alignment gauge  (with integrated angle measurement box).

    G15858274Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Steering wheel alignment gauge (example)

    CAUTION: Electrically moved components 
    • Danger of limbs being trapped 

      → Switch off electric power to drive motor.

      → Make sure it does not switch on again.

      → Check that there is no electric charge.

    Information 

    The PDCC system can be active when the ignition is switched on (even when the vehicle is stationary). To avoid injury/crushing, only work near the anti-roll bar, lower trailing arm and bellows of the steering gear when the ignition is switched off and always allow for the run-on time of 60 seconds.

  2. Loosen lock nut -2-  and counter at the tie-rod ball -3-  .

    Information 

    Make sure that the bellows are not twisted after turning the tie rods!

  3. Adjust the toe at the left and right wheel using the hexagon -1-  .
  4. Tighten lock nut -2-  and check the toe value again > Tightening torque 90 Nm (67 ftlb.) 
    G15858275Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Adjusting front-axle toe