Replacing Power-Steering Gear

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Loosen universal joint -1- on power-steering gear.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Universal joint mounting
1. 1.1 Unscrew screw -2- and replace it.
2. 1.2 Pull universal joint off the pin on the steering gear and slide it towards the steering column.
Release and disconnect cable plug -2- on front speed sensor -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for front speed sensor

Loosen tie-rod ball -1- on the wheel bearing housing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for tie-rod ball on wheel bearing housing

3.1 Unscrew nut -2- on joint pin for the tie-rod ball as far as required so that it is flush with the upper edge of the joint pin.

3.2 Press off joint pin for tie-rod ball using >T10187 - press-out tool. >Pressing off joint pin

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pressing off joint pin

3.3 Unscrew nut -2- from joint pin for the tie-rod ball.

Disconnect electric line -1- on the power-steering gear -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric connectors on power-steering gear
1. 4.1 Release and disconnect cable plug -3- .
2. 4.2 Loosen bracket -4- .
Remove screws on secondary bearing for power-steering gear -1 and 2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screw joint for secondary bearing on power-steering gear
1. 5.1 Unscrew screw -1- and counter at the hexagon nut -2- .
2. 5.2 Replace threaded connection.
Remove threaded joints -2- on the main bearing of the power-steering gear -1- .
Get another person to hold the power-steering gear.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for power-steering gear
Remove power-steering gear in a downward direction.