Technical Values
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
| *Location | *Description | *Type | *Basic value | *Tolerance 1 | *Tolerance 2 |
|---|---|---|---|---|---|
| Mounting anti-roll bar to body | M12 x 1.5 x 90 thread/always replace bolts following removal. | Initial tightening | 70 Nm (51.6 ftlb.) | ||
| Mounting anti-roll bar to body | M12 x 1.5 x 90 thread/always replace bolts following removal. | Final tightening | + 180° | ||
| Strut with mounting anti-roll bar to body | M12 x 1.5 x 90 thread/always replace bolts following removal. | Initial tightening | 70 Nm (51.6 ftlb.) | ||
| Strut with mounting anti-roll bar to body | M12 x 1.5 x 90 thread/always replace bolts following removal. | Final tightening | + 180° | ||
| Strut to body | Hexagon-head bolt, M10 x 25/always replace bolts following removal. | Initial tightening | 50 Nm (36.9 ftlb.) | ||
| Strut to body | Hexagon-head bolt, M10 x 25/always replace bolts following removal. | Final tightening | + 45° | ||
| Mounting anti-roll bar to front axle carrier (side) | Hexagon-head bolt, M10 x 35/always replace bolts following removal. | Initial tightening | 50 Nm (36.9 ftlb.) | ||
| Mounting anti-roll bar to front axle carrier (side) | Hexagon-head bolt, M10 x 35/always replace bolts following removal. | Final tightening | + 30° | ||
| Mounting anti-roll bar to power-steering gear | Hexagon-head bolt, M8 x 80 with hexagon nut/always replace bolts and nuts following removal. | Initial tightening | 20 Nm (14.8 ftlb.) | ||
| Mounting anti-roll bar to power-steering gear | Hexagon-head bolt, M8 x 80 with hexagon nut/always replace bolts and nuts following removal. | Final tightening | + 180° | ||
| Mounting anti-roll bar to front axle carrier (front) | Round head screw, M8 x 20 with hexagon nut/always replace screws following removal. | Initial tightening | 20 Nm (14.8 ftlb.) | ||
| Anti-roll bar mount to front axle carrier (front) | Round head screw, M8 x 20 with hexagon nut/always replace screws following removal. | Final tightening | + 30° | ||
| Fasten holder for high-voltage lines to mounting anti-roll bar | Item 2: Hexagon-head bolt M6 x 16 | Tightening torque | 8 Nm (5.9 ftlb.) | ||
|
Holder for high-voltage lines on mounting anti-roll bar |
|||||