Installing Connecting Link For Anti-Roll Bar
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Tighten nut -2-
> Initial tightening 20 (1 5 ftlb.) Nm
> Final tightening + 45° WARNING: Wheel bearing housing raised incorrectly
- Risk of crushing
- Risk of damage to components
→ Wear personal protective gear.
→ Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
Information
Threaded joints must only be tightened in zero position to prevent warping in the bearings.
- Lift the wheel bearing housing as far as required using lifting equipment (e.g > VAS 6931 - Transmission and Engine Jack
) until the lower trailing arm is horizontal > Zero position (shown on rear axle as an example)
Zero position (shown on rear axle as an example)
- Install threaded joint -3-
.
Conventional: > Initial tightening 70 (52fdb.) Nm > Final tightening + 90°
PDCC: > Initial tightening 70 Nm (52 ftlb.) > Final tightening + 90°
Mounting for connecting link for anti-roll bar