LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (40 Wheel Suspension Front Drive Shaft 2.9L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 407719 Removing And Installing Front Anti-Roll Bar (PDCC) >> Removing And Installing Front Anti-Roll Bar >> Removing Front Anti-Roll Bar

Removing Front Anti-Roll Bar

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove wire harness for PDCC -1-  .
    G15857615Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting for PDCC wire harness

    1. 1.1 Unscrew fastening screw for ground line -2-  .
    2. 1.2 Loosen bracket -3-  .
    3. 1.3 Release and disconnect electric plug connections from the PDCC control unit in the sequence -1 to 5-  .
    G15857616Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Sequence for disconnecting the electric plug connections

  2. Unscrew fastening screws -3-  for the connecting links -1-  on both sides of the vehicle.
    G15857617Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting for connecting link for anti-roll bar

  3. Remove anti-roll bar clamps -1-  .
    G15857618Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting for anti-roll bar clamps

    1. 3.1 Unscrew fastening screws -2-  .
scientia non olet · About LEMON Manuals