Removing Coolant Pump
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Incorrect handling of pulley
- Risk of damage to pulley
→ The pulley is sensitive to impact. Do not prise off the pulley with a screwdriver.
→ Do not re-use a damaged pulley.
Information
The pictures and graphics shown may differ from the original depending on engine variants, additional equipment and/or country specifications.
However, the technical accuracy of the specifications is guaranteed.
Information
- To ease removal, spray the pulley from the rear side with an anti-corrosion agent.
- Remove air guide at the radiator frame.
- 1.1 Remove clips -2- .
- 1.2 Remove air guide -1- by pulling it upwards.
Upper radiator frame air guide (Figure V6 Biturbo)
- Remove coolant pipe -1-
.
- 2.1 Unscrew and remove fastening screws -2- .
- 2.2 Remove coolant pipe -1- .
Coolant pipe coolant pump
- Remove pulley -1-
.
- 3.1 > T10172A - Counter-hold tool must be fitted on the pulley -1- , then unscrew fastening screws -2- .
- 3.2 Remove belt pulley -1- .
Coolant pump belt pulley
- Remove coolant pipe -1-
over the coolant pump.
- 4.1 Unscrew and remove fastening screws -2- .
- 4.2 Disconnect coolant pipe -1- from the cylinder head at the right and from the shut-off valve.
Coolant pipe on cylinder head
- Remove coolant pump -9-
.
- 5.1 Pull off vacuum hose -8- .
- 5.2 Unscrew fastening screws -1 to 7- one after the other in this sequence.
- 5.3 Remove coolant pump -9- . Catch escaping coolant.
Fastening screws for coolant pump