Removing Control Unit For Distance Measuring Sensor
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Voltage peaks
- Risk of damage to electrical load or to the control unit
→ Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).
→ Switch off electrical loads before disconnecting or removing them.
Information
Always comply with the regulations for handling ESD-sensitive components!
- Always wear approved work clothes and shoes when carrying out assembly work.
- Do not remove new part from ESD (electrostatic discharge) protective packaging until shortly before installation and only at the installation position.
- Do not touch electric pins and plug contacts.
Information
The distance measuring sensor control unit is integrated into the right ACC sensor and cannot be removed separately.
- Remove control unit for distance measuring sensor -2-
.
Removing control unit for distance measuring sensor
- 1.1 Unscrew and remove screws -1- .
- 1.2 Loosen control unit for distance measuring sensor -2- until the electric plug connection -3- is accessible.
- 1.3 Release and disconnect electric plug connection -3- .