LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (27 Starter, Power Supply, Cruise Control 2.9L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 270719 Removing And Installing 48-Volt Auxiliary Battery >> Installing 48-Volt Auxiliary Battery

Installing 48-Volt Auxiliary Battery

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit 48-volt additional battery in the boot floor plate and move it against the stop -arrow-  .
    G15877661Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Installation position of 48-volt additional battery

  2. Fit the securing frame -5-  and secure it with the four fastening screws -4-  > Tightening torque 8 Nm (6 ftlb.)  .
    G15877662Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Securing 48-volt additional battery

  3. If installed, insert the battery vent line -3-  into the 48-volt additional battery. Check the battery vent line for damage and correct routing.
    G15877663Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Connecting 48-volt additional battery

  4. Connect electric connector -6-  to the 48-volt additional battery until the connector engages securely.
  5. Fit the two electric lines on the battery terminals and secure them with the fastening nuts -2-  > Tightening torque 8 Nm (6 ftlb.) 
  6. Fit and lock the two terminal caps on the 48-volt additional battery.
  7. Position air duct correctly.
    G15877664Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Air duct

scientia non olet · About LEMON Manuals