Installing Torque Support
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Move torque support -1-
into installation position.
- Fit and -2-
tighten new screws M10 x 70 and M10 x 80.
> Initial tightening 50 Nm (36.9 ftlb.)
> torque angle + 90°
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Torque support - V8 Turbo
- Secure the strut -4-
.
- 3.1 Screw in and tighten screw -5-
.
> Initial tightening 20 Nm (15 ftlb.)
> Final tightening + 90°
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Screws for strut