LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (10 Engine - Crankcase, Suspension 2.9L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 101320 Removing And Installing Oil Spray Jet >> Removing Oil Spray Jet

Removing Oil Spray Jet

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove oil windage tray -1-  .
    G15822031Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Oil windage tray (shown on V6)

    1. 1.1 Unscrew screws -2-  and remove oil windage tray -1-  .

    Information 

    The crankshaft must be turned only in direction of rotation of the engine.

  2. Turn the crankshaft -1-  .
    G15822032Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Crankshaft

    1. 2.1 Turn the crankshaft -1-  using > T40263 - wrench, 21 mm-2-  and > T40314 - adapter-3-  until the connecting rod bolts are accessible.

    Information 

    For re-installation, mark the installation position and allocation of the connecting-rod bearing caps to the cylinder and to the connecting rod.

  3. Remove the relevant connecting-rod bearing caps -1-  .
    G15822033Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Connecting-rod bearing cap

    1. 3.1 Unscrew screw -2-  and remove connecting-rod bearing cap -1-  .
  4. Remove the relevant oil spray jet -1-  .
    G15822034Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Oil spray jet

    1. 4.1 Unscrew screw -2-  .
    2. 4.2 Remove oil spray jet -1-  .
  5. To remove other oil spray jets, repeat the procedure on the relevant oil spray jets.
scientia non olet · About LEMON Manuals