Technical Values
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Screws on coolant control valve | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Screws securing generator bracket to crankcase | Replace following removal. | Initial tightening | 8 Nm (6 ftlb.) | ||
| Screws securing generator bracket to crankcase | Replace following removal. | Final tightening | + 90° | ||
| Screw securing tensioning roller for air-conditioning compressor to air-conditioning compressor bracket | Tightening torque | 25 Nm (19 ftlb.) | |||
| Aluminium screw securing air-conditioning compressor bracket to crankcase | Replace following removal. | Initial tightening | 8 Nm (6 ftlb.) | ||
| Aluminium screw securing air-conditioning compressor bracket to crankcase | Replace following removal. | Final tightening | + 90° | ||
| Screw for deflection roller (generator) | M8 x 16.9 x 65 x 50 | Tightening torque | 25 Nm (19 ftlb.) | ||
| Screw securing shaft cover to oil guide housing | M6 x 16 (2 ea.) | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/replace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/replace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing chain housing cover to oil windage tray | M6 x 25 (2 ea.)/replace, observe tightening sequence | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing chain housing cover to oil windage tray | M6 x 25 (2 ea.)/replace, observe tightening sequence | Final tightening | + 90° | ||
| Banjo bolt for oil spray jet | Initial tightening | 10 Nm (7.5 ftlb.) | |||
| Banjo bolt for oil spray jet | Final tightening | + 45° | |||
| Screws on return line adapter | Tightening torque | 9 Nm (6.6 ftlb.) |