Installing Steering Column

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

Replace screw for Centre of steering column (universal joint).

Installation is performed in reverse order. Pay particular attention to the following:
Screw in and tighten screw securing steering column to Centre of steering column (universal joint) > Initial tightening 20 Nm (15 ftlb.) . + > Final tightening torque angle + 90°

Screw in and tighten nuts securing steering column to retaining frame in tightening sequence -4 to 7-. > Tightening torque 20 (15itlb.) Nm

Fig 1: Steering Column Nuts Tightening Sequence
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screwing on nuts