LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (66 Exterior Equipment - Coupe -- 971 - PANAMERA (971)) >> WM, 663119 Removing And Installing Door Entry Guard >> Removing Sill Cover

Removing Sill Cover

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Unscrew and remove screw -1-  .
    G15864896Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Loosening door entry guard

  2. Unscrew and remove screws -2-  .
    G15864897Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Loosening door entry guard mounting

    Information 

    • The sill cover (door entry guard) can only be removed and installed when the doors are open. The illustration shows the vehicle without doors for the sake of clarity  .
  3. Starting at the front, unclip door entry guard completely in direction -A-  , then in direction -B-  .
    G15864898Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Unclipping door entry guard

    G15864899Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Unclipping door entry guard

  4. Guide door entry guard out of the door gap at the front and rear and remove door entry guard.
    G15864900Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing door entry guard

  5. Check clips for damage. Replace damaged clips or sealing washers.
G15864901Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing clips

G15864902Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installing clips