LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (80 Heater - Coupe -- 971 - PANAMERA (971)) >> WM, 803719 Removing And Installing Additional Pump >> Removing Additional Pump

Removing Additional Pump

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Danger of scalding 
  • Coolant can be very hot. 
  • Coolant may be pressurised. 

    → Only remove the heater when the cooling system has cooled down.

    → By carefully opening the catch on the reservoir, make sure that the cooling system is depressurised.

NOTE: Danger of slipping due to emerging coolant 
  • The emerging coolant will make the floor of the workshop slippery and may cause people to slip and fall over. 

    → Collect emerging coolant in a suitable pan.

  1. Observe safety measures for working on vehicles with auxiliary heating.

    > 8X00IN SAFETY MEASURES WHEN WORKING ON VEHICLES WITH AUXILIARY HEATING

  2. Close off hose -1-  and hoses -2-  using > V.A.G 1275A - hose clamp pliers  .
  3. Open spring band clamps -3-  using > VAS 6889 - spring band clamp pliers  and disconnect hoses -1-  and -2-  .
    G15874796Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Pulling off hoses

  4. Release and unplug electric plug connection -5-  .
    G15874797Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Releasing and pulling off electric plug connection

  5. Remove additional pump -7-  .
    1. 5.1 Unscrew and remove screws -6-  .
    2. 5.2 Remove additional pump -7-  .
      G15874798Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Additional pump in wheel housing

scientia non olet · About LEMON Manuals