Installing Cover For Front Backrest

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Risk of damage to cover if excessive heat is applied.

Creases in cover
→ If creases have formed, only short partial warming with the hot-air gun is permissible.

→ The hot-air temperature of 50°C must always be observed.

Information

Replace upholstery rings and hang in integrated metal braces of the cover.
Fasten cover to the padding, starting at the inside.

Installation is performed in reverse order. Pay particular attention to the following:
Fit cushion rings using > V.A.G 1634B - Cushion Clip Pliers .
If creases have formed, partially heat affected areas of the cover with the hot-air gun and smooth out the cover using special tools:
> 9747 - Wetting-off iron

> 9747/1 - Knurling iron

> 9747/2 - Bone burnisher

> V.A.G 1416 - Hot-Air Blower