LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (6X Body-Equipment Outside-General - Coupe 971 - PANAMERA (971)) >> WM, 6X00IN30 Working With Adhesive Tape And Adhesive Pads >> Working With Adhesive Tape And Adhesive Pads >> Preparing Bonding Surfaces

Preparing Bonding Surfaces

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Initial cleaning 

Remove sticky, solid layers such as dirt, rust and old adhesive.

Cleaning 

Then clean the bonding flange areas using a lint-free cloth soaked in isopropanol until there are no more residues on the cloth.

Leave cleaned surfaces to dry off for 15 minutes; the bonding surfaces must be completely dry.

scientia non olet · About LEMON Manuals