Assembling Shock Absorber

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Fit stop buffer -1- and protective sleeve -2- .
1. 1.1 Fit protective sleeve -2- on stop buffer -1- .
2. 1.2 Slide stop -1- buffer with protective sleeve -2- onto piston rod.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Stop buffer and protective sleeve
Slide supporting washer -1- onto piston rod -2- and check that the cut-out in the supporting washer is positioned correctly in relation to the piston rod.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Support washer
Fit shock absorber mounting -1- .
1. 3.1 Slide the shock absorber mounting -1- onto the piston rod -3- as far as the support washer stop.
2. 3.2 Screw on the nut -2- and tighten using > T10001 - shock absorber set while at the same time holding back the multiple-tooth screw of the piston rod -3- .
  > Tightening torque 53 Nm (39.1 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Shock absorber mounting