LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (42 Rear Wheel Suspension Drive Shaft 2.9L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 429019 Removing And Installing Rear Anti-Roll Bar (PDCC) >> Technical Values

Technical Values

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Location Description Type Basic value Tolerance 1 Tolerance 2
Anti-roll bar mount to rear axle housing Item 2: Hexagon-head bolt, M8x 35/always replace bolts following removal! Initial tightening 20 Nm (15 ftlb.)    
G15857955Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for anti-roll bar mount
Anti-roll bar mount to rear axle housing Item 2: Hexagon-head bolt, M8x 35/always replace bolts following removal! Final tightening torque angle + 90°    
G15857956Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for anti-roll bar mount
Protective plate on PDCC actuator to rear axle housing Item 2: Hexagon-head bolt, M6x25 Tightening torque 8 Nm (6 ftlb.)    
G15857957Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for protective plate on PDCC actuator
PDCC wire harness to rear axle housing Item 2: Hexagon-head bolt, M6x30 Tightening torque 8 Nm (6 ftlb.)    
G15857958Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for PDCC Sport wire harness on rear axle housing
Bearing protective plate to rear axle housing Item 2: Hexagon-head bolt M5 Tightening torque 7 Nm (5.2 ftlb.)    
G15857959Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Protective plate mount