LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 135 (42 Rear Wheel Suspension Drive Shaft 2.9L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 429019 Removing And Installing Rear Anti-Roll Bar (PDCC) >> Removing And Installing Rear Anti-Roll Bar (PDCC) >> Removing Rear Anti-Roll Bar (Pdcc)

Removing Rear Anti-Roll Bar (Pdcc)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove protective plate on the rear axle housing bearing -1-  on both sides of the vehicle.
    G15857960Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting for protective plate

    1. 1.1 Unscrew fastening screws -2-  .
  2. Disconnect PDCC wire harness at the PDCC control unit (observe specified sequence!).
    G15857961Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Sequence for disconnecting the electric plug connections

    1. 2.1 Release and disconnect electric plug connections from the PDCC control unit in the sequence -1 to 5-  .
  3. Expose PDCC wire harness -1-  .
    G15857962Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting for PDCC wire harness

    1. 3.1 Unscrew fastening screw on the rear axle housing -2-  .
    2. 3.2 Unscrew fastening screw for ground line -3-  .
    3. 3.3 Remove PDCC wire harness from the brackets -4-  .
  4. Remove protective plate on PDCC actuator -1-  .
    G15857963Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting for protective plate on PDCC actuator

    1. 4.1 Unscrew fastening screws -2-  .
  5. Disconnect PDCC wire harness -1-  at the rear axle housing.
    G15857964Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting for PDCC wire harness on rear axle housing

    1. 5.1 Unscrew fastening screw -2-  .
  6. Remove anti-roll-bar mount -1-  .
    G15857965Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting for anti-roll-bar mount

    1. 6.1 Unscrew fastening screws -2-  .
  7. With the help of another person, turn the anti-roll bar alternately -arrow A-  to the right and guide it out -arrow B-  . Carefully guide out the PDCC wire harness as well.
    G15857966Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Guiding out anti-roll bar

scientia non olet · About LEMON Manuals