Intake-Air Distributor (V6 Monoturbo)
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Intake-air distributor - V6 monoturbo
| 1 | Centre intake-air distributor |
| 2 | Throttle valve |
| 3 | Seal/replace if damaged |
| 4 | Screws > Tightening torque 7 Nm (5 ftlb.) |
| 5 | Pressure sensor |
| 6 | Screw > Tightening torque 5 Nm (3.5 ftlb.) |
| 7 | Holder |
| 8 | Screw > Tightening torque 9 Nm (6.5 ftlb.) |
| 9 | Screws > Tightening torque 7 Nm (5 ftlb.) |
| 10 | Seal/replace if damaged |
| 11 | Screws, M6 x 25/observe tightening sequence > Initial tightening 8 Nm (6 ftlb.) > Final tightening + 45° |
| 12 | Seal/replace if damaged |
| 13 | Intake-air distributor, left and right |
| 14 | Temperature sensor |
| 15 | Screw > Tightening torque 9 Nm (6.5 ftlb.) |
| 16 | Screw > Tightening torque 9 Nm (6.5 ftlb.) |
Tightening sequence for intake-air distributor
Tightening sequence for intake-air distributor - V6 biturbo
| 1-10 | Tightening sequence for intake-air distributor screws - V6 Turbo |