WM, 2X00IN Battery Trickle Charge: Information
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Using charging cables/jump leads directly on the vehicle battery.
- Risk of damage to battery sensor
→ Always connect charging cables/jump leads to the external power supply for jump-lead starting.
Information
- When working or carrying out tests on the vehicle or when the vehicle is in the workshop, a battery charger with a current rating of at least 90 A must be connected.
- As soon as the vehicle is unlocked, e.g. the vehicle is in the workshop or salesroom, it must be trickle-charged using a battery charger.
Information
When using an original standard vehicle electrical system battery , a charge voltage of 14.4 volts or even 14.8 volts (setting on the charger) can be applied.
- Open protective cover on the positive terminal for jump-lead starting.
- First, connect the positive cable from the charger to the positive terminal.
- Connect the negative cable from the charger to the ground point for jump-lead starting.
- Read operating instructions for the charger.
- Switch off all loads.
- Switch on the charger.