LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (72 Seat Frames - Coupe -- 971 - PANAMERA (971)) >> WM, 724919 Removing And Installing Side Cushion >> Removing Side Cushion

Removing Side Cushion

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Improper handling of airbag unit 
  • Triggering the airbag unit. 
  • System faults can occur. 

    → Switch off ignition and remove ignition key or handheld transmitter.

    → A voltage supply (e.g. battery charger) must not be connected to the external power supply/jump-lead starting terminals.

    → Disconnect the battery and insulate the ground strap so that all contact with a ground carrier is avoided.

    → Wait 1 minute after disconnecting the battery.

    → Only disconnect the connector from the triggering unit after the waiting time has elapsed.

    → Make sure that no foreign objects are located in front of the airbag unit during installation.

    → Replace damaged parts during removal.

    → Always position airbag units so that the blow-out opening is facing upwards, e.g. crest on driver's airbag.

    → Do not place any objects on the airbag units.

    → If removed for an extended period, the airbag units must be stored in a safe place.

    → Airbag units must not come into contact with grease, oil, cleaning agents, liquids or similar substances.

    → Do not expose airbag units to temperatures of more than 90°C.

    → Do not remove the short-circuit spring on the plug contacts.

    → Triggering and preparations may only be carried out by skilled staff, supervised by a second responsible person.

    → Before disposal, the airbag unit must be rendered harmless by triggering it electrically while observing all precautionary measures, thereby preventing it from being used incorrectly.

WARNING: Incorrect handling of safety bolts 
  • Danger of injury 
  • Loss of torque 

    → Always use new screws or nuts following removal.

    → Comply with instructions for repairs.

    → Observe specified tightening torques.

    → Carry out a visual inspection of parts used.

  1. Fold the backrest over and unclip cover -4-  .
    G15873852Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Unclipping cover

  2. Only for vehicles with electric rear-seat backrest (I-no. 3KK or 3KL) 

    Adjust rear-seat backrest adjuster until screw -2-  is accessible.

    G15873853Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Adjusting rear-seat backrest adjuster

  3. Unscrew screw -2-  and detach side cushion -1-  .
    G15873854Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Unscrewing screw

    Information 

    The number of electric plug connections will vary depending on equipment.

  4. Release and disconnect electric plug connections -3-  and remove side cushion -1-  .
    G15873855Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing side cushion

scientia non olet · About LEMON Manuals