Group 10 - Engine - Crankcase, Suspension: Crankcase
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Crankcase
| 1 | Crankcase |
| 2 | Roll pin (4x) |
| 3 | Throttle pin for water jacket (4x) |
| 4 | Dowel sleeve (2x) |
| 5 | Oil duct filler |
| 6 | Screw plug, M22 x 1.5 (2 x water rail plugs/2 x oil duct plugs)/replace sealing ring > Initial tightening 30 Nm > Final tightening + 30° |
| 7 | Screw plug, M14 x 1.5/> Tightening torque 15 Nm (11 ftlb.) |
| 8 | Screw plug, M14 x 1.5 (crankshaft staking bore)/remove all-round sealing coating completely and fit O-ring > Tightening torque 25 Nm (19 ftlb.) > Tightening torque 20 Nm (15 ftlb.) |
| 9 | Screws, M8 x 30/replace/observe tightening sequence |
| 10 | Bearing blocks |
| 11 | Dowel sleeve, 24 mm long (10x) |
| 12 | Screws, M10 x 111/replace/observe tightening sequence |