Tightening Sequence For High-Pressure Fuel Lines

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fuel Collection Pipe Screws Tightening Sequence - V8 Turbo

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tightening sequence for fuel collection pipe - V8 Turbo

1-10	Tightening sequence for fuel collection pipe

Tightening sequence for high-pressure pump and lines:

Fit union nut -1- by hand.
1. 1.1 Coat thread on union nuts with Microgleit DF 977S. Leave to dry off for at least 5 minutes before fitting.
Screw high-pressure pump -2- into position.
Fit union nut -3- by hand.
1. 3.1 Coat thread on union nuts with Microgleit DF 977S. Leave to dry off for at least 5 minutes before fitting.
Fit screws -4- for the high-pressure pump.
Fit screw -5- with holder by hand.
Press down the high-pressure pump and tighten screws -4- .
> Tightening torque 12 Nm (9 ftlb.)
Tighten screw -5- .
> Tightening torque 9 Nm (6.5 ftlb.)
Tighten union nuts -1- and -3- .
> Initial tightening 8 Nm (6 ftlb.)

> Final tightening + 50°

Fig 2: High-Pressure Lines Screws And Nuts Tightening Sequence
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tightening sequence for high-pressure lines