Removing Chain Housing Cover

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

The procedure for removing and installing is described for one side as an example. The procedure for the other side is almost identical.

Release and disconnect electric plug connection -2- at the relevant actuators.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Camshaft controller actuator

Only for cylinder bank 1:

2.1 Remove additional coolant pump holder -1- .

2.1.1 Unscrew nut -2- .
2.1.2 Unscrew double-screws -3- and press additional coolant pump holder -1- aside.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Additional coolant pump holder

Remove chain housing cover -1- .
1. 3.1 Unscrew screws -2- .
2. 3.2 Press off chain housing cover -1- at a suitable point and set it down on a clean surface.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Upper chain housing cover, right