Installing Chain Housing Cover

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

Fitting and sealing components using liquid sealant.

Clean sealing faces to remove all traces of residual sealant.
Sealing faces must be free of grease and oil.
Clean sealing faces with primer Loctite 7515.
Use liquid sealant Loctite 5970-BM.

Apply liquid sealant Loctite 5970-BM -1- on the chain housing cover.

1.1 Install the chain housing cover within five minutes of applying the liquid sealant.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Applying sealant on right chain housing cover

Install chain housing cover -1- .

2.1 Fit chain housing cover -1- on cylinder head.

2.2 Fit and tighten screws -2- uniformly.

> Tightening torque 9 Nm (6.5 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Upper chain housing cover, right

Only for cylinder bank 1:

3.1 Fit additional coolant pump holder -1- .

3.1.1 Fit and tighten double-screws -3- .
> Tightening torque 9 Nm (6.6 ftlb.)

3.1.2 Fit and tighten nut -2- .

> Tightening torque 9 Nm (6.6 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Run-on pump holder