Install Intake Pipe

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

O-rings must always be replaced.
O-rings must be coated lightly with Kluber Syntheso Glep.

Install intake pipe.
1. 1.1 Check seal on intake pipe and replace it if damaged.
2. 1.2 Replace O-rings on the Venturi tube.
3. 1.3 Tighten screws securing intake pipe to turbocharger to > Tightening torque 9 Nm (6.5 ftlb.) .
4. 1.4 Tighten screw securing intake pipe to pressure pipe to > Tightening torque 9 Nm (6.5 ftlb.) .
Install intake hose.
1. 2.1 Tighten screw-type clamp on intake pipe with > Tightening torque 3.5 Nm (2.5 ftlb.)
2. 2.2 Tighten screw-type clamp on air box for air cleaner with > Tightening torque 3.5 Nm (2.5 ftlb.)
Left side only:
1. 3.1 Check O-rings and replace them if damaged.
2. 3.2 Connect positive crankcase ventilation line -1- to the oil separator. -2-
3. 3.3 Not installed for every variant:
  Connect electric connector -3- to the positive crankcase ventilation valve.