Removing Tie-Rod Ball

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

To make it easier to remove the tie-rod ball, swivel the relevant wheel bearing housing so that the tie rod is fully extended.
Release and disconnect electric connector -2- from the front speed sensor -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for front speed sensor

Remove tie-rod ball -1- on the wheel bearing housing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for tie-rod ball on wheel bearing housing

3.1 Unscrew nut -2- on joint pin for the tie-rod ball until it is flush with the upper edge of the joint pin.

3.2 Press off joint pin for tie-rod ball using > T10187 - Press-out tool > Pressing off joint pin

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pressing off joint pin

3.3 Unscrew nut -2- from joint pin for the tie-rod ball.
Information

Mark the position of the tie-rod ball on the thread before unscrewing it from the tie rod.

Count the number of turns when unscrewing it (turns of tie-rod ball).

This avoids the need to perform an approximate adjustment of the steering trapeze during reassembly.

This does not replace suspension alignment.

Remove tie-rod ball -1- from the tie rod.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Detaching tie-rod ball
1. 4.1 Counter the tie-rod ball -1- at the flattened areas -arrows- using a suitable open-ended wrench.
2. 4.2 Unscrew lock nut -2- .