Installing Crankcase Cover

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

Fitting and sealing components using liquid sealant.

Clean sealing faces to remove all traces of residual sealant.
Sealing faces must be free of grease and oil.
Clean sealing faces with primer Loctite 7515.
Use liquid sealant Loctite 5970-BM.

Information

Replace O-ring.

Apply liquid sealant Loctite 5970-BM -1- on the crankcase cover.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Applying sealant on crankcase cover
Install crankcase cover.
1. 2.1 Fit crankcase cover uniformly on the oil guide housing and crankcase.
2. 2.2 Fit screws uniformly and tighten in the sequence -1 to 10- .
  > Tightening torque 9 Nm (6.5 ftlb.)
  
  Fig 1: Crankcase Cover Screws Tightening Sequence
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  
  Crankcase cover