LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Taycan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (10 Engine - Crankcase, Suspension 4.0L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 100127 Removing And Mounting Engine (V8 Hybrid) >> Mounting Engine

Mounting Engine

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2023 Porsche Panamera, 2022 Porsche Panamera, 2021 Porsche Panamera, 2020 Porsche Panamera, and 2019 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mount engine on front-axle carrier.
    1. 1.1 Lower engine with workshop crane and > 3033 - lifting tackle  onto the front-axle carrier and move it into installation position.
  2. Left side of engine:
    1. 2.1 Carefully guide in drive shaft -1-  and insert it into the all-wheel final drive console -2-  (-arrow-  ). Check that the drive shaft is seated securely.

      > 404119 REMOVING AND REINSTALLING FRONT DRIVE SHAFT

    2. 2.2 Fit engine mount -4-  on engine carrier -5-  .
      1. 2.2.1 Fit and tighten screw -3-  .

        > Initial tightening 70 Nm (52 ftlb.) 

        > Final tightening + 90° 

        G15824310Courtesy of PORSCHE CARS NORTH AMERICA, INC.

        Drive shaft and left engine mount (V8 biturbo engine)

  3. Right side of engine:
    1. 3.1 Carefully guide in drive shaft -1-  and insert it into the all-wheel final drive -2-  (-arrow-  ). Check that the drive shaft is seated securely.

      > 404119 REMOVING AND REINSTALLING FRONT DRIVE SHAFT

    2. 3.2 Fit engine mount -4-  on engine carrier -5-  .
      1. 3.2.1 Fit and tighten screw -3-  .

        > Initial tightening 70 Nm (52 ftlb.) 

        > Final tightening + 90° 

        G15824311Courtesy of PORSCHE CARS NORTH AMERICA, INC.

        Drive shaft and right engine mount (V8 biturbo engine shown)

  4. Secure coolant lines -1-  to the front-axle carrier -2-  at the left.
    1. 4.1 Secure coolant lines -1-  in the holders -arrows-  .
    G15824312Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Coolant lines on front-axle carrier

  5. Secure coolant line -1-  to the ATF cooler -2-  .
    G15824313Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Coolant line on ATF cooler

  6. Secure front coolant lines -1-  .
    1. 6.1 Connect coolant line -1-  and secure with a clamp -2-  .
    G15824314Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Coolant line for coolant pump

  7. Secure coolant line to the power electronics.

    > Refer to the appropriate Service Information for Removing and installing power electronics for high-voltage system

scientia non olet · About LEMON Manuals