Removing Main Wire Harness Section For Rear Lid At The Right
NOTE:
Voltage peaks
- Risk of damage to electrical load or to the control unit
→ Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).
→ Switch off electrical loads before disconnecting or removing them.
Information
When cutting the wire harness, make sure there is enough length of cable left to join to the new lines.
- Release and disconnect electric plug connections on rear-end electronics control unit.
> 578919 REMOVING AND INSTALLING CONTROL UNIT FOR REAR-END ELECTRONICS
- Release and disconnect electric plug connection on rear right shock absorber.
- Loosen rear fuse box.
- Loosen main wire harness section for rear lid at the right -1-
.
Main wire harness section for rear lid at the right
- 4.1 Unclip cable duct -2- (-arrow A- ).
- 4.2 Unscrew nuts on ground points at right C-pillar -3- .
- 4.3 Unclip rear right connection point holder -4- (-arrow B- ).
- 4.4 Unclip clips -5- .
- Cut main wire harness section for rear lid at the right -1-
in areas -x-
.
Separation points
- Loosen main wire harness section for rear lid at the right -1-
.
Main wire harness section for rear lid at the right
- 6.1 Unclip clips -2- .
- 6.2 Guide main wire harness section for rear lid at the right -1- out of holder -3- .
- 6.3 Remove main wire harness section for rear lid at the right -1- .
- Guide out main wire harness section for rear lid at the right -1-
(-arrow-
).
Main wire harness section for rear lid at the right
- Release and disconnect electric plug connections on control unit for rear spoiler.
> 667419 REMOVING AND INSTALLING CONTROL UNIT FOR REAR SPOILER
- Release and disconnect electric plug connection on mobile communication antenna on rear lid.
> 914719 REMOVING AND INSTALLING MOBILE COMMUNICATION ANTENNA ON REAR LID
- Release and disconnect electric plug connection on SDARS antenna.
- Release and disconnect electric plug connection on upper part of rear lock.
- Remove main wire harness section for rear lid at the right -1-
.
Main wire harness section for rear lid at the right
- 12.1 Unclip clips -2- .
- 12.2 Remove main wire harness section for rear lid at the right -1- .