Installing Front Roof Sun Blind

Information 

After installing the sun blind, check that it moves smoothly and easily. Check sun blind drive mechanism at the motor by actuating it manually. To do this, move the sun blind forward and back manually using a commercially available hexagon wrench and check the sun blind fabric for creases and distortion.

Information 

The sun blind sliders and operating cables for the sun blind must not be greased.

1. Installation is performed in reverse order. Pay particular attention to the following:

   Screw in and tighten screw securing sun blind to frame > Tightening torque 2 Nm (1.5 ftlb.) +/- 0.3 Nm (0.2 ftlb.)