Installing Rear Spoiler Seal

1. Remove adhesive residues using erasing disc.
2. Clean bonding surface with isopropyl.
3. Pull off protective film at one corner of the new rear spoiler seal.
4. Install rear spoiler seal -1-  .
   1. 4.1 Fit rear spoiler seal -1-  at the corner -arrow A-  and align it so that it is flush with the upper edge.
   2. 4.2 Pull off protective film on new rear spoiler seal -1-  by detaching 15 to 20 cm at a time and press on new rear spoiler seal -1-  along its entire length.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Installing rear spoiler seal

5. Fit lower part of spoiler -1-  in installation position with respect to the marking -arrow A-  .

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Setting installation position of lower part of spoiler

6. Screw in and tighten screws -1-  > Tightening torque 5.6 Nm (4.1 ftlb.) 

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screwing in and tightening screws