Welding Work

WARNING: This page is about a different variant/trim than selected.

Information

The oxyacetylene welding process must not be used for welding body parts made of high-strength, very-high-strength and ultra-high-strength steel!
Carry out test-welding before starting resistance spot-welding!

All specified steel panels can be welded using the approved resistance spot-welders.

The MIG welding process can only be used on ultra-high-strength steel in exceptional cases! Details of where this process can be used can be found in the relevant repair instructions. The MIG welding process can be used without restriction on all other specified steel panels.