LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 75 (42 Rear Wheel Suspension Drive Shaft 4.0L Turbo Gas -- 971 - PANAMERA (971)) >> WM, 422119 Removing And Installing Drive Shaft >> Removing And Installing Drive Shaft >> Installing Drive Shaft

Installing Drive Shaft

WARNING: This page is about a different variant/trim than selected.
  1. Replace shaft sealing ring in the final drive

    > Refer to the appropriate Service Information for Removing and installing sealing ring for output flange

  2. Replace circlip -1-  on the drive shaft.
    G15861936Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Circlip

    Information 

    • Make sure not to damage the sealing ring when guiding the drive shaft into the final drive.
    • Check that the profile splines on the drive shaft and transmission side interlock securely!
    • The use of an impact tool is not permitted.
  3. Fit drive shaft -1-  into the final dive with a quick jerking movement -arrow-  .
    G15861937Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fitting drive shaft into final drive

  4. Check that the joint is seated correctly in the final drive.
    1. 4.1 Hold the joint with both hands and pull outwards.
    2. 4.2 If the drive shaft can only be pulled out again using considerable force, the drive shaft is fitted correctly.
    3. 4.3 Press the drive shaft back into the final drive if necessary.
scientia non olet · About LEMON Manuals