Removing Load-Through Provision Mount

WARNING: This page is about a different variant/trim than selected.

Pull off spacer sleeve -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Spacer sleeve
Pull out bearing pin -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bearing pin
Unclip bearing sleeve -3- from load-through provision.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bearing sleeve

Detach cover for rear backrest -1- in the lower area.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cover for rear backrest
Carefully press the padding down until the relevant nut -1- is accessible.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Padding

Information

To unscrew the bearing pin, counter at the inner nut using a wrench.
Unscrew the relevant bearing pin -2- and remove it.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bearing pin