LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 45 (63 Bumper - Wagon -- 971 - PANAMERA (971)) >> WM, 635719 Removing And Installing Rear Retaining Strip >> Installing Retaining Strip With Heat Shield

Installing Retaining Strip With Heat Shield

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order.
  2. Screw in and tighten nuts on retaining strip with heat shield > Tightening torque 9 Nm (6.6 ftlb.) 
  3. Screw in and tighten screw on retaining strip with heat shield > Tightening torque 2.5 Nm (1.8 ftlb.) 
scientia non olet · About LEMON Manuals